Table of Contents
Advertisement
Symbol
198
Description
Adjust positioning point seam begin./center/end
•
Adjust positioning point seam begin. (100 mm - 300 mm)
•
Adjust positioning point seam center (100 mm - 300 mm)
•
Adjust positioning point seam end (100 mm - 300 mm)
Adjust transport clamp p. 200
Adjust needle thread-clamp/-catcher/-tension p. 201
Adjust corner knife distance (reference pocket length)
• 20 - 240 mm
Adjust corner knife
•
Adjust cutting duration (0 ms - 1000 ms)
set maximum hook thread counter
• only visible in global parameters if
hook thread monitor is deactivated in the machine
configuration p. 188
•
Maximum hook thread counter On/Off
•
Use the numeric keypad to enter the length of the hook thread
in meters which will fit on the bobbin
Adjust guiding plates and folder height p. 202
Needle thread monitor On/Off
Select flap clamp feeding mode
•
open both together
•
Pedal forward = open left
Pedal back = open right
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
Programming
Advertisement
Table of Contents
