Table of Contents
Advertisement
Programming
Control panel OP7000
All settings for the machine are performed using the OP7000 control
panel.
The activation of the sewing motor and the stepper motors is performed
by the DAC comfort control in conjunction with the OP7000 control panel
with the user interface in symbolic representation.
Fig. 82: Control panel OP7000
Switching on the machine
After the machine has been switched on, the control and the OP7000
control panel will start up. Next, the machine prompts the user to start
the reference run on the control panel.
The user must enable the machine for use after the display of the welcome
message goes out. Follow the instructions shown on the display for this
purpose:
To switch on the machine:
1. Press the pedal.
The control panel is enabled.
106
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
Advertisement
Table of Contents
