Table of Contents
Advertisement
Operation
Fig. 46: Stripe correction (2)
7. Accurately align the jacket front part below the clamped flap as per
8. Press the right pedal forward.
The vacuum is switched on.
9. Press the left pedal forward.
The turning device swivels back and transfers the flap to the open
Fig. 47: Stripe correction (3)
10. If a lateral shift from the pattern is discernible after sewing, this shift
11. Take off the flap before repositioning and re-aligning it.
12. Sew on and check the flap; correct again if necessary.
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
the pattern.
flap feeding device. The flap is fed and sewn on.
can be offset by using stripe correction in the software ( p. 184):
Shift of the flap to the left = lower value
Shift of the flap to the right = higher value
without correction
with correction
57
Advertisement
Table of Contents
