Ssh Server Configuration - Panasonic GA-ML Series Manual

3.5.4.

SSH Server Configuration

Press H (command) on the screen of the System Security Configuration, and then
you can see "SSH Server Configuration" as Figure 3-13. You can configure the
SSH servers on this screen. This device supports SSHv2, only. Use a client that sup-
ports the SSHv2 to connect.
PNxxxxxx Local Management System
Basic Switch Configuration -> SSH Server Configuration
SSH UI Idle Timeout:
SSH Auth. Idle Timeout:
SSH Auth. Retries Time:
SSH Server:
SSH Server key:
-------------------------------- <COMMAND> -----------------------------------
[G]enerate SSH Server key
Set SSH UI Time [O]ut
Set SSH Authentication [R]etries Time [Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Screen Description
SSH UI Idle Timeout
SSH Auth. Idle Timeout
SSH Auth. Retries Time
SSH Server
SSH Server key
3 Min.
120 Sec.
3
Disabled
Key exists
Figure 3-13: SSH Server Configuration
Displays the time needed as the unit of minute until a session is killed
(or disconnected) if nothing is entered when connecting remotely using
the SSH. The factory default settings is 3 minutes (180 seconds).
Displays the response time for the SSH authentication. The factory
default settings is 2 minutes (120 seconds).
Displays the number of retransmitting the SSH authentications. The
factory default settings is three (3) times.
Displays if the SSH ensures access (or accessibility). The factory default
settings is set to "Disabled".
Enabled (SSH)
Disabled
Displays the status of the SSH server key of RSA method. The status of
the factory default settings is set to "Key exists".
Key exists.
Key does not exist.
Enable/Disable SS[H] Server
Set SSH [A]uthentication Time Out
Accessible
Inaccessible
A server key exists.
A server key does not exist.
46