Table of Contents
Advertisement
3.6.5.
Display MAC Address by VLAN ID
Press V (command) on the Forwarding Database Menu, and then the appearance
of the command prompt becomes "Enter VLAN ID>". Designate the port-num-
ber, and then you can see "Display MAC Address by VLAN ID" as Figure 3-20.
This screen can also display a MAC address table per VLAN.
PNxxxxxx Local Management System
Forwarding Database Menu -> Display MAC Address by VLAN ID
Age-Out Time: 300 Sec.
MAC Address
-----------------
-------------------------------- <COMMAND> -----------------------------------
[N]ext Page
[P]revious Page
Set [A]ge-Out Time
Command>
Enter the character in square brackets to select option
Figure 3-20: Display MAC Address by VLAN ID
Screen Description
Age-Out Time
Displays time to save (or store) a MAC address table. The time means the time
after receiving packets during the previous time (or at the last time). The factory
default settings is 300 seconds (5 minutes).
Select VLAN ID
Displays the VLAN ID selected.
MAC Address
Displays MAC address in a MAC address table.
Port
Displays a port that a MAC address belongs to.
The following describes commands to be used on this screen.
N
Displays the next page.
Press N (command) to display the next page.
P
Displays the previous page.
Press P (command) to display the previous page.
A
Configures the storage time (keeping time) of MAC address.
Press A (command), and then the appearance of the command prompt becomes "Enter Age-
Out time>". After that, configure time needed in the range from 10 to 1,000,000 (seconds).
S
Switches VLAN to display.
Press S (command), and then the appearance of the command prompt becomes "Enter VLAN
ID>". Enter the VLAN ID to be displayed.
Q
Returns to the top menu.
Selected VLAN ID: 1
Port
----
[S]elect VLAN ID
[Q]uit to previous menu
55
Advertisement
Table of Contents
