Egress Rate Limiting Configuration - Panasonic GA-ML Series Manual

4.5.4.

Egress Rate Limiting Configuration

Press E (command) on the Quality of Service Configuration menu, and then you
can see Egress Rate Limiting Configuration Menu as Figure 4-29. This screen allows
you to configure the control of the bandwidth.
PNxxxxxx Local Management System
Quality of Service Configuration -> Egress Rate Limiting Configuration Menu
Port Bandwidth
---- ----------- --------
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12 -
Note: Bandwidth - 1Mbps/unit
-------------------------------- <COMMAND> -----------------------------------
[N]ext Page
[P]revious Page
Set [B]andwidth
Command>
Enter the character in square brackets to select option
Figure 4-29: Egress Rate Limiting Configuration
Screen Description
Port
Bandwidth
Status
Status
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Set [S]tatus
[Q]uit to previous menu
Displays the port-number.
Displays the bandwidth. The factory default settings is set to 1,000 (Unit:
Mbps).
Displays if the status of a bandwidth control is enabled or disabled.
Enabled The status of a bandwidth control is enabled.
Disabled The status of a bandwidth control is disabled.
113