Snmp Trap Receiver Configuration Menu - Panasonic GA-ML Series Manual

3.2.2.

SNMP Trap Receiver Configuration Menu

Press T (command) on the SNMP Configuration Menu, and then you can see SNMP
Trap Receiver Configuration Menu as Figure 3-5. You can configure to transmit
SNMP traps on this screen. See the section 3.2.1 when configuring privilege (Read-
Write/Read-Only) of the destination of SNMP traps.
PNxxxxxx Local Management System
SNMP Configuration -> SNMP Trap Receiver Configuration Menu
Trap Receiver List:
No. Status
---- --------
1 Enabled
2 Disabled
3 Disabled
4 Disabled
5 Disabled
6 Disabled
7 Disabled
8 Disabled
9 Disabled
10 Disabled
-------------------------------- <COMMAND> -----------------------------------
Set Receiver [S]tatus
Set Trap [T]ype
Command>
Enter the character in square brackets to select option
Figure 3-5: SNMP Trap Receiver Configuration Menu
Screen Description
Trap Displays the IP address and the community name of a trap-destination that is con-
Receiver List figured currently.
No.
Trap
Status
Type
IP Address
Community
Type IP Address
----- ---------------
v1 172.16.222.1
v1 0.0.0.0
v1 0.0.0.0
v1 0.0.0.0
v1 0.0.0.0
v1 0.0.0.0
v1 0.0.0.0
v1 0.0.0.0
v1 0.0.0.0
v1 0.0.0.0
Set Receiver [I]P
Set Receiver [C]ommunity
Displays the entry number of the trap destination.
Displays if traps need to be sent.
Enable Transmits (or sends) traps.
Disable Does not transmit traps.
Displays the type of traps.
v1 Transmits SNMP v1 traps.
v2c Transmits SNMP v2c traps.
Displays the host IP address of SNMP manager.
Displays the community name, which is currently configured when
transmitting traps.
26
Community
----------------------------
public
In[d]ividual Trap Config
[Q]uit to previous menu