Panasonic GA-ML Series Manual page 116

The following describes commands to be used on this screen.
N Displays the next page.
Press N (command) to display the next page.
P Displays the previous page.
Press P (command) to display the previous page.
U Set the threshold of Unicast.
1. Press D (command), and then the appearance of the command prompt becomes "Enter
port-number>". Enter the port-number to specify (or designate).
2. The appearance of the command prompt becomes "Select threshold value mode >".
Press 1 to select pps, 2 to select kbps, and 3 to select ratio.
3. The appearance of the command prompt becomes "Enter threshold value>". In the
case of designating pps, enter that in the range from 0 to 1,488,100. In the case of des-
ignating kbps, enter in the range from 0 to 1,000,000. In the case of designating ratio,
enter in the range from 1 to 100.
B Set the threshold of Broadcast.
1. Press B (command), and then the appearance of the command prompt becomes "Enter
port-number>". Enter the port-number to specify (or designate).
2. The appearance of the command prompt becomes "Select threshold value mode >".
Press 1 to select pps, 2 to select kbps, and 3 to select ratio.
3. The appearance of the command prompt becomes "Enter threshold value>". In the
case of designating pps, enter that in the range 0 and 1488100. In the case of
designating kbps, enter in the range from 0 to 1,000,000. In the case of designating
ratio, enter in the range from 1 to 100.
M Set the threshold of Multicast.
1. Press M (command), and then the appearance of the command prompt becomes
"Enter port-number>". Enter the port-number to specify (or designate).
2. The appearance of the command prompt becomes "Select threshold value mode >".
Press 1" for selecting pps, 2 for kbps, and 3 for ratio.
3. The appearance of the command prompt becomes "Enter threshold value>". In the
case of designating pps, enter that in the range from 0 to 1,488,100. In the case of
designating kbps, enter in the range from 0 to 1,000,000 . In the case of designating
ratio, enter in the range from 1 to 100.
S Set Storm Control Action.
1. Press S (command), and then the appearance of the command prompt becomes "Enter
port-number>". Enter the port-number to specify (or designate).
2. The appearance of the command prompt becomes "Select port action type (D/N/S)>".
Press D to delete packets that exceed the upper threshold, N if filtering is not performed,
and S to shut down a port.
Q Returns to the top menu.
116