Loop Detection Configuration Menu - Panasonic GA-ML Series Manual

4.11.1. Loop Detection Configuration Menu

Press D (command) on the Advanced Switch Configuration menu, and then you
can see Loop Detection Configuration Menu as Figure 4-51. You can configure a
function of detecting and blocking a loop on this screen. For the network configu-
ration, see the section 5.4 for "Example of network configuration with the func-
tion of detecting and blocking a loop and caveats".
PNxxxxxx Local Management System
Advanced Switch Configuration -> Loop Detection Configuration Menu
Global Loop Detection Status: Enabled
Port Trunk Link
---- ----- ---- ----------- ------------- -------- ---------- ---------------
1 --- Up
2 --- Down Forwarding
3 --- Down Forwarding
4 --- Down Forwarding
5 --- Down Forwarding
6 --- Down Forwarding
7 --- Down Forwarding
8 --- Down Forwarding
9 --- Down Forwarding
10 --- Down Forwarding
11 --- Down Forwarding
12 --- Down Forwarding
-------------------------------- <COMMAND> -----------------------------------
[N]ext Page
[P]revious Page
[E]nable/Disable Loop Detection
Loop History [I]nformation
Command>
Enter the character in square brackets to select option
Figure 4-51: Loop Detection Configuration Menu
Screen Description
Global Loop
Detection Status
Port
Trunk
Link
State
Loop Detect
State Loop Detect
Forwarding Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Disabled
Disabled
Displays the condition of the function of detecting and blocking a loop.
Enabled The function of detecting and blocking a loop is enabled
(factory default settings).
Disabled The function of detecting and blocking a loop is disabled.
Displays the port-number.
Displays the group ID of a link aggregation.
Display the condition of a link-up.
Up In the progress of becoming a link-up
Down In the progress of becoming a link-down
Displays the operation of the function of detecting and blocking a loop.
Forwarding Packets are transferred normally.
Loop Detect A loop is detected, and a port is blocked.
Displays the condition of the function of detecting and blocking a loop per
port.
Enabled The function of detecting and blocking a loop is enabled
(factory default settings: Ports from 1 to 24).
Disabled The function of detecting and blocking a loop is disabled
(factory default settings: Ports from 25 to 28).
Mode Recovery
Block Enabled
Block Enabled
Block Enabled
Block Enabled
Block Enabled
Block Enabled
Block Enabled
Block Enabled
Block Enabled
Block Enabled
Block Enabled
Block Enabled
Set Port [L]oop Detect Status
Set Port Recovery [S]tatus
Set Port Recovery [T]imer
[Q]uit to previous menu
157
Recovery Time
60
60
60
60
60
60
60
60
60
60
60
60