Table of Contents
Advertisement
4.10.1. Ring Redundant Protocol Configuration
Press R (command) on the Advanced Switch Configuration menu, and then you
can see "Ring Redundant Protocol Configuration" as Figure 4-47. You can config-
ure a ring protocol on this screen.
PNxxxxxx Local Management System
Advanced Switch Configuration -> Ring Redundant Protocol Configuration
RRP Status : Disabled
Domain Name
------------------------- ----------- ------------ ----------- ---------
-------------------------------- <COMMAND> -----------------------------------
Set RRP [S]tatus
[C]reate RRP Domain
S[h]ow RRP Domain information
Command>
Enter the character in square brackets to select option
Figure 4-47: Ring Redundant Protocol Configuration
Screen Description
RRP Status
Displays the condition of the function of a ring protocol.
Enabled
Disabled
Total Domain
Displays the number of domains registered. (Registering up to 8 groups is possible.）
Number
Domain
Displays a domain name.
Name
Ctrl VLAN
Displays the VLAN ID for controlling.
Data VLAN(s) Displays the VLAN ID for data.
Ring Status
Displays the ring condition (or status).
IDLE
Complete
Failed
Link-Up
Link-Down
Pre-Forwarding
Total Domain Number : 0
Ctrl VLAN Data VLAN(s) Ring Status Node Type
[M]odify RRP Domain
[D]elete RRP Domain
[Q]uit to previous menu
The function of a ring protocol is enabled.
The function of a ring protocol is disabled (factory default
settings).
Indicates that the function of a ring protocol is disabled.
Indicates that a ring topology is accurately configured. Only
Master node is displayed for this status.
Indicates that a ring topology is not configured. Only master
node is displayed for this status.
Indicates that a ring topology is accurately configured. Only
transit node is displayed for this status.
Indicates that a ring protocol is not configured. This status dis-
plays a transit node, only.
Indicates that a ring topology is in the progress of being config-
ured. This status displays transit node, only.
149
Advertisement
Table of Contents
