Set Port Priority - Panasonic GA-ML Series Manual

4.2.4.

Set Port Priority

Press G (command) on the Trunk Configuration Menu, and then you can see
"LACP Status" as Figure 4-11. You can check the status of LACP group on this
screen. (The status can be displayed for only keys whose mode is "Active" or
"Passive".)
PNxxxxxx Local Management System
Trunk Configuration Menu -> Set Port Priority
System Priority :
System ID
Group ID
Aggregator
---------- -------------------------------- --------------------------------
1
-------------------------------- <COMMAND> -----------------------------------
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Screen Description
System Priority This is the priority of this device, which is necessary for configuring the trunking
on the network using the LACP. The lower a (numeric) value is, the higher the pri-
ority will be. 1 is configured to the factory default settings.
System ID This is the ID of this device which is necessary for configuring the trunking on the
network using the LACP. The MAC address of this device becomes the ID, and is
not changeable. The combination of the System Priority (value) and the System
ID becomes the system ID on the LACP.
Key Displays the group number for a trunking.
Aggregator This is the number for the logical interface of a trunking. The aggregator
becomes the same with the port-number with the highest value of port priority
among ports configuring the trunking.
Attached Port This is the number for the physical interface (ports) connected to the logical inter-
List face (Aggregator). If the trunking group, which exceeds 9 ports, is configured,
the port with the lower value of the port priority becomes the backup mode to
display the standby.
Standby Port List If the trunking group, which exceeds 9 ports, is configured, the port with the
lower value of the port priority becomes the back up mode. This field (or column)
displays the appropriate ports.
The following describes commands to be used on this screen.
Q Returns to the top menu.
32768
: xx:xx:xx:xx:xx:xx
: 1
Attached Port List
Figure 4-11: Set Port Priority
Standby Port List
1
88