Panasonic GA-ML Series Manual page 150

Node Type Displays a node role.
Master
Transit
The following describes commands to be used on this screen.
S Configures to enable or disable the function of a ring protocol.
Press S (command), and then the appearance of the command prompt becomes "Enable
or Disable RRP status (E/D)>". After that, Press E to enable and D to disable.
C Creates a new domain.
Press C (command), and then the appearance of the screen becomes the RRP Domain
Creation Menu. See the next section (4.10.2) for the content.
D Deletes a domain configured.
Press D (command), and then the appearance of the command prompt becomes "Enter RRP
Domain Name >". After that, enter the name of a domain to be deleted.
M Modifies a domain configured.
Press M (command), and then the appearance of the command prompt becomes "Enter
RRP Domain Name >". Enter a domain name to be configured. After that, the appearance
of the screen becomes the RRP Domain Modification Menu. See the next section (4.10.3) for
the content.
H Displays the domain information.
Press H (command), and then the appearance of the command prompt becomes "Enter
RRP Domain Name >". After that, enter a domain name to display the information. The
appearance of the screen becomes the RRP Domain information Menu. See the next section
(4.10.4) for the content.
Q Returns to the top menu.
-------------------------------------------------------------------------------------------------------------------------------------------
Note: In addition, you cannot use a function of a ring protocol and the Internet Man-
sion mode, as a combination.
-------------------------------------------------------------------------------------------------------------------------------------------
-------------------------------------------------------------------------------------------------------------------------------------------
Note: For the ports configuring a ring protocol, configure to disable a function of
detecting and blocking a loop in advance. See the section (4.11.1) for the detailed con-
figuration method for the function of detecting and blocking a loop.
-------------------------------------------------------------------------------------------------------------------------------------------
Indicates a switch to control a ring operation. Set one master
node on a domain.
Indicates a switch other than a master node.
150