Panasonic GA-ML Series Manual page 27

The following describes commands to be used on this screen.
S Configures to enable or disable a trap-destination.
1. Press S (command), and then the appearance of the command prompt becomes "Enter
manager entry number>. After that, enter the entry number of the trap-destination to be
configured.
2. The appearance of the command prompt becomes "Enable or Disable Trap Receiver (E/
D)>". Then press E to enable the SNMP manager, and D to disable it.
I Configures the host IP address of the SNMP manager.
1. Press I (command), and then the appearance of the command prompt becomes "Enter
manager entry number>. After that, enter the entry number of the trap destination to be
configured.
2. The appearance of the command prompt becomes "Enter IP Address for trap
receiver>". Enter the IP address.
D Configures the trap-transmission when changing the link condition.
Press D (command), and then the appearance of the screen becomes Enable/Disable
Individual Trap Menu. See the section (3.2.2.) for the detailed configuration.
T Configures the type of traps.
1. Press T (command), and then the appearance of the command prompt becomes "Enter
manager entry number>". After that, enter the entry number of the trap destination to
be configured.
2. The appearance of the command prompt becomes "Enter the selection>". Press 1 to set
a trap to SNMP v1, and "2" to set it to SNMP v2c.
C Configures the community name of the trap destination.
1. Press C (command), and then the appearance of the command prompt becomes "Enter
manager entry number>". After that, enter the entry number of the trap-destination to
be configured.
2. The appearance of the command prompt becomes "Enter community name for trap
receiver>". Enter the community name.
Q Returns to the top menu.
27