Panasonic GA-ML Series Manual page 189

The following describes commands to be used on this screen.
I Configures the IP address of an opponent destination to execute Ping.
Press I (command), and then the appearance of the command prompt becomes "Enter IP
address>".
After that, enter an IP address for that.
N Configures the number of operating Pings.
Press N (command), and then the appearance of the command prompt becomes "Enter
new number of requests>". Enter the number of operating. Enter the numeric value in the
range from 1 to 10 as it is possible up to 10 times.
T Configures the time until the time-out occurs.
Press T (command), and then the appearance of the command prompt becomes "Enter
new Timeout Value >". After that, enter the time with the unit of seconds. Five seconds is
the maximum. Configure it in the range from 1 to 5 seconds.
E Executes the Ping command. In addition, clearing the display is possible.
Press E (command), and then the appearance of the command prompt becomes "Execute
Ping or Clean Ping Data (E/C)>". Press E to execute, and C to clear the display, only.
S Stops operating the Ping command.
Press S during the execution of Ping, or Press Ctrl+C to stop.
Q Returns to the top menu.
PN262492 Local Management System
Ping Execution -> IPv4 Ping Execution
Target IP Address:
Number of Requests:
Timeout Value:
=============== Result ===================
No. 1
No. 2
No. 3
No. 4
No. 5
Waiting for response...
-------------------------------- <COMMAND> -----------------------------------
Set Target [I]P Address
Set [N]umber of Requests
Set [T]imeout Value
S or Ctrl-C Stop ping function
xxx.xxx.xxx.xxx
10
3 Sec.
0.268 ms
0.272 ms
0.268 ms
0.270 ms
0.276 ms
[E]xecute Ping
[S]top Ping
[Q]uit to previous menu
Figure 6-8 B: Screen for Ping Execution
189