Ipv6 Ping Execution - Panasonic GA-ML Series Manual

6.5.1.

IPv6 Ping Execution

Press 6 at the Ping Execution, and then you can see "IPv6 Ping Execution" as fol-
lows. You can confirm the communication to the terminal connected and other
devices by executing the IPv6 Ping command from the Switch, on this screen.
PNxxxxxx Local Management System
Ping Execution -> IPv6 Ping Execution
Target IP Address:
Number of Requests:
Timeout Value:
=============== Result ===================
-------------------------------- <COMMAND> -----------------------------------
Set Target [I]P Address
Set [N]umber of Requests
Set [T]imeout Value
Command>
Enter the character in square brackets to select option
Screen Description
Target IP Address
Number of Request
Timeout Value
The following describes commands to be used on this screen.
I Configures the IP address of the (opponent) destination to execute Ping.
Press I (command), and then the appearance of the command prompt becomes "Enter new
Target IPv6 Address>". After that, enter the IP address.
N Configures the number of Pings.
Press N (command), and then the appearance of the command prompt becomes "Enter
new number of requests>>". After that, enter the number of times.
Enter the number in the range from 1 to 10; the maximum number of times is 10.
T Configures the time until the screen becomes time-out.
Press T (command), and the command prompt becomes "Enter new Timeout Value>". Enter
the time by using seconds as the unit. Configure the time in the range from 1 to 5 as 5 sec-
onds is set for the maximum time.
E Executes the Ping command. You can also clear the display.
Press E (command), and then command prompt becomes "Execute Ping or Clean Ping
Data(E/C)>". Press E to execute, and C for clearing the display, only.
::
10
3 Sec.
[E]xecute Ping
[S]top Ping
[Q]uit to previous menu
Figure 6-10 A: IPv6 Ping Execution
Displays the IPv6 address of the (opponent) destination to execute Ping.
"::" is displayed on the factory default settings.
Displays the number of Pings (to execute). The number is set to 10 for the
factory default settings.
Displays the time needed until the screen becomes time-out. The factory
default settings is 3 seconds. The content of Result Ping is displayed.
190