Display Mac Address By Port - Panasonic GA-ML Series Manual

3.6.3.

Display MAC Address by Port

Press P (command) on the Forwarding Database Menu, and then the appearance
of the command prompt becomes "Enter port number>". Specify the port-
number, and then you can see "Display MAC Address by Port" as Figure 3-18.
You can display a MAC address table per port on this screen.
PNxxxxxx Local Management System
Forwarding Database Menu -> Display MAC Address by Port
Age-Out Time: 300 Sec.
MAC Address
-----------------
-------------------------------- <COMMAND> -----------------------------------
[N]ext Page
[P]revious Page
Set [A]ge-Out Time
Command>
Enter the character in square brackets to select option
Screen Description
Age-Out Time
Displays the time to save the MAC address table.
Displays the time passed after receiving packets during the last time.
The factory default settings is 300 seconds (5 minutes).
Select Port Displays the port-number selected.
MAC Address Displays the MAC address on a MAC address table.
Port Displays a port belonging to a MAC address.
The following describes commands to be used on this screen.
N Displays the next page.
Press N (command) to display the next page.
P Displays the previous page.
Press P (command) to display the previous page.
A Configures the storage time of a MAC address.
Press A (command), and then the appearance of the command prompt becomes "Enter
Age-Out time>". Next, configure the time in the range from 10 to 1,000,000 (seconds).
S Switches the port to display.
Press S (command), and then the appearance of the command prompt becomes "Enter
port-number>". After that, enter the port-number to be displayed.
Q Returns to the top menu.
Port
----
Figure 3-18: Display MAC Address per Port
Selected Port: 1
[S]elected Port No
[Q]uit to previous menu
53