Mst Instance Configuration - Panasonic GA-ML Series Manual

4.4.6.

MST Instance Configuration

Press M (command) and MST instance ID on the screen of MSTP Instance
Configuration, and then you can see "MST Instance Configuration" as Figure 4-
21. You can perform the advanced settings regarding the MST instance on this
screen.
PNxxxxxx Local Management System
MST Instance Configuration -> MST Instance Configuration
MSTI Root Port:
MSTI Root Cost:
MSTI Regional Root:0
-------------------------------- <COMMAND> -----------------------------------
Set MSTI Bridge Pr[i]ority
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Screen Description
MSTI Root Port Displays the route port-number of MST instance.
MSTI Root Cost Displays the value of route path cost of MST instance.
Time Since Displays the elapsed time (seconds) after changing the configuration of a
Topology spanning tree.
Change
Topology Displays the number of that configuration of a spanning tree is changed.
Change Count
MSTI Regional Displays a bridge ID of a regional route bridge of MST instance.
Root
MSTI Bridge ID Displays the bridge ID of MST instance.
The following describes commands to be used on this screen.
I Configures a bridge priority of MST instance.
Press I (command), and then the appearance of the command prompt becomes "Enter
MSTI Priority>". Enter the value of the bridge priority. Enter the value of a bridge priority.
Q Returns to the top menu.
0
0
000000000000 MSTI Bridge ID:
Figure 4-21: MST Instance Configuration
Time Since Topology Change: 0
Topology Change Count:
8000 000000000000
103
Sec.
0