Panasonic GA-ML Series Manual page 196

● Is the cable connected to the port (from one to four) which supports the PoE
power supply function?
● Does a single port or the whole device cause an overload?
● Is the PoE power-receiving equipment (which is connected to corresponding ports)
compatible with the standard of IEEE802.3af or the one of IEEE802.3at?
● Is the upper limit of power supplying manually configured in the range from
15,600 to 30,000mW? (When you supply powers to the PoE and power-receiving
equipment, which is not compatible with the IEEE802.3at.)
If the port LED (right) lights:
● Does the supplying power, which the PoE power-receiving equipment requires,
exceed 62W as a whole device?
If the power-supply stops suddenly:
● There is the possibility that the PoE power-receiving equipment, whose power con-
sumption is different between normal usage time and standby, is used. Check the
PoE LIM (PoE limit) LED.
● A single port must not be overloaded. (The port LED [right one] must not flash.)
Or, it must not exceed the power supplying of the whole device. (Check if the PoE
LIM [PoE limit] does not flash.)
197