Traffic Class Configuration - Panasonic GA-ML Series Manual

4.5.2.

Traffic Class Configuration

Press T (command) on the Quality of Service Configuration menu, and then you
can see "Traffic Class Configuration" as Figure 4-27. You can configure QoS and
a traffic class on this screen.
PNxxxxxx Local Management System
Quality of Service Configuration -> Traffic Class Configuration Menu
CoS-queue map:
CoS QID
--- ---
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
-------------------------------- <COMMAND> -----------------------------------
Scheduling Method [C]onfig.
Set Priority-Traffic Class [M]apping
Command>
Enter the character in square brackets to select option
Screen Description
CoS
QID
The following describes commands to be used on this screen.
M Assign (or allocate) the priority level (Traffic Class) to the Priority value of IEEE802.1p.
1. Press M (command), and then the appearance of the command prompt becomes
"Enter Cos>". Enter the Cos value to assign (or allocate).
2. The appearance of the command prompt becomes "Enter queue ID ofr Cos #>". Then
enter the number for Cos-map in the range from 0 to 7.
C Moves to the configuration screen of a scheduling method.
1. Press C (command), and then the appearance of the command prompt becomes "Enter
port-number>". Enter the port-number as the target.
2. The appearance of the screen becomes "Scheduling Method". See the next section
(4.5.3) for this configuration content.
Q Returns to the top menu.
Figure 4-27: Traffic Class Configuration
Displays the Priority value in the VLAN tag.
Displays the priority of a traffic class.
0: Lowest
7: Highest
[Q]uit to previous menu
110