Danfoss Vacon OPTEA Operating Manual page 21

VACON® NXP Advanced Safety Options
Operating Guide
CUT HAZARD FROM SHARP EDGES
There can be sharp edges in the AC drive that can cause cuts.
-
Wear protective gloves when mounting, cabling, or doing maintenance operations.
BURN HAZARD FROM HOT SURFACES
Touching surfaces, which are marked with the 'hot surface' sticker, can result in injury.
-
Do not touch surfaces which are marked with the 'hot surface' sticker.
DAMAGE TO THE AC DRIVE FROM STATIC VOLTAGE
Some of the electronic components inside the AC drive are sensitive to ESD. Static voltage can damage the components.
-
Remember to use ESD protection always when working with electronic components of the AC drive. Do not touch the com-
ponents on the circuit boards without proper ESD protection.
DAMAGE TO THE AC DRIVE FROM MOVEMENT
Movement after installation can damage the drive.
-
Do not move the AC drive during operation. Use a fixed installation to prevent damage to the drive.
DAMAGE TO THE AC DRIVE FROM INCORRECT EMC LEVEL
The EMC level requirements for the AC drive depend on the installation environment. An incorrect EMC level can damage the
drive.
-
Before connecting the AC drive to the mains, make sure that the EMC level of the AC drive is correct for the mains.
RADIO INTERFERENCE
In a residential environment, this product can cause radio interference.
-
Take supplementary mitigation measures.
MAINS DISCONNECTION DEVICE
If the AC drive is used as a part of a machine, the machine manufacturer must supply a mains disconnection device (refer to EN
60204-1).
MALFUNCTION OF FAULT CURRENT PROTECTIVE SWITCHES
Because there are high capacitive currents in the AC drive, it is possible that the fault current protective switches do not operate
correctly.
Danfoss A/S © 2021.06
C A U T I O N
C A U T I O N
N O T I C E
N O T I C E
N O T I C E
N O T I C E
N O T I C E
N O T I C E
AQ319736045637en-000101 / DPD01798 | 21
Safety