Use Picocom In Linux - Digi XB3-C-A2-UT series User Manual

Get started with MicroPython
6. In the Tera Term: Serial port setup window, set the parameters to the following values:
Port: Shows the port that the XBee Smart Modem is connected on.
n
Baud rate: 115200
n
Data: 8 bit
n
Parity: none
n
Stop: 1 bit
n
Flow control: hardware
n
Transmit delay: N/A
n
7. Click OK to apply the changes to the serial port settings. The settings should go into effect
right away.
8. To verify that local echo is not enabled and that extra line-feeds are not enabled:
a. In Tera Term, click Setup and select Terminal.
b. In the New-line area of the Tera Term: Serial port setup window, click the
c. Make sure the Local echo box is not checked.
9. Click OK.
10. Press Ctrl+B to get the MicroPython version banner and prompt.
Now you can type MicroPython commands at the >>> prompt.

Use picocom in Linux

With the XBee Smart Modem in MicroPython mode (AP = 4), you can access the MicroPython prompt
using a terminal.
Note The user must have read and write permission for the serial port the XBee Smart Modem is
connected to in order to communicate with the device.
Digi XBee3 Cellular LTE-M Global Smart Modem User Guide
Receive drop-down menu and select CR if it does not already show that value.

Use picocom in Linux

55