Menu Items - MUTOH ValueCut II VC2-600 User Manual

ValueCut USER MANUAL

3.4 Menu Items

Below describes the functions of menu items
Menu or Key
Place Media To instruct the user to lower the lever after the material is
And Then loaded.
Lower Down When the medium is loaded, the user will be requested to
The Lever lower the lever; once the lever is lowered, users can proceed
to the three sizing modes (Roll / Edge / Single).
Roll To measure media width.
Edge To measure media width and pull the media back till the front
paper sensor open.
Single To measure media width and length.
To indicate the power status.
1. To move the tool carriage position on X or Y axis.
2. To select functions or change values of settings.
1. The displayed parameters will be saved automatically.
2. To set a new origin at the present tool carriage position.
To temporarily halt the cutting process.
To resume the process by press [Pause/Resume] key again.
VC2E-A-00
In "offline" mode, moving the tool carriage to desired
position by [Arrow Keys], then press [ENTER] key to set a
new origin. While moving with the parameters of XY-axes
displayed, press [MISC] key will enable fine-tune
movement; press [MISC] key again to disable the function.
Metric (cm/gf) or English
measurement (inch/oz)
Function
--- Media sizing ---
--- POWER ---
[ Arrow Keys ]
[ ENTER ]
[ PAUSE/RESUME ]
41
Control Panel
Setting Default
Maximum Tracking
150 meters
Maximum Tracking
150 meters
Maximum Tracking
10 meters