Menu Items - MUTOH ValueCut Series User Manual

3.4

Menu Items

Below describes the functions of menu items
Menu or Key
Place Media To instruct the user to lower the lever after the material is
And Then loaded.
Lower Down When the medium is loaded, the user will be requested to
The Lever lower the lever; once the lever is lowered, users can proceed
to the three sizing modes (Roll/Edge/Single).
Roll To measure media width.
Edge To measure media width and pull the media back till the front
paper sensor open.
Single To measure media width and length.
To indicate the power status.
1. To move the tool carriage position on X or Y axis.
2. To select functions or change values of settings.
1. The displayed parameters will be saved automatically.
2. To set a new origin at the present tool carriage position.
In "offline" mode, moving the tool carriage to desired
position by [Arrow Keys], then press [ENTER] key to set a
new origin. While moving with the parameters of XY-axes
displayed, press [MISC] key will enable fine-tune
movement; press [MISC] key again to disable the function.
To temporarily halt the cutting process.
To resume the process by press [Pause/Resume] key again.
1. To switch between online mode and offline mode.
2. To stop the cutting job or abort the change of setting.
Once press this key, the cutting job will be terminated
immediately and cannot be resumed.
To set or modify the distance between the blade tip and the
center axis.
Please refer to section 4.3 or Chapter A-2 for more
information.
To set or modify the value of tool force.
When the cutting force exceeds 450g, the maximum cutting
speed would be 15cm/sec and the cutting quality would be
Small Letter Mode (0.2g) and while the cutting force is
300g-449g, the maximum cutting speed would be 30 cm/sec
and the cutting quality would be Fine Mode (0.5g)
Speed To set or modify tool down speed at horizontal moving.
The Control Panel
Function
--- Media sizing ---
--- POWER ---
[ Arrow Keys ]
[ ENTER ]
[ PAUSE/RESUME ]
[ ONLINE/OFFLINE ]
[ OFFSET ]
[ FORCE ]
[ SPEED ]
3-5
ValueCut User Manual
Setting Default
Maximum Tracking
150 meters
Maximum Tracking
150 meters
Maximum Tracking
10 meters
0.000~1.000mm 0.275mm
5~600gram; 80 gram
5 gram/per step
3~153cm/sec; 72cm/sec
3cm/sec per step