Authentication - Axis 7000 User Manual

AXIS 7000/FX User's Manual

Authentication

If the administrator has enabled authentication the user must enter a
user name and password to gain access to the AXIS 7000/FX. If the
authentication process is not enabled, proceed to the next
section"Sending to Destinations" on page 80.
1. When the following display appears, enter your user name and
press Menu (on the control panel) or Tab (on the keyboard).
User Name:
2. Enter your password and press Menu (on the control panel) or
press Tab (on the keyboard):
Password:
3. The following message will appear:
Login in progress
4. If the following message appears the authentication process has
failed. Press Cancel (on the control panel) or press Esc (on the
keyboard) to try again.
Login failed!
5. If the authentication process is successful the following message is
displayed informing you that you can log out by pressing Cancel for
two seconds (on the control panel) or Esc (on the keyboard).
To logout press
Cancel 2 sec.
6. To continue press any key or wait until the following message
appears:
Send to:
xxxxxx
Using the AXIS 7000/FX
79