Updating The Flash Memory - Axis 7000 User Manual

122
Updating the Software

Updating the Flash Memory

Be careful not to interrupt the file transfer. If the transfer is interrupted, the AXIS 7000/FX may
have to be re-initialized by your dealer.
Before you begin:
To upgrade over the network you will need the following:
• The file with the new AXIS 7000/FX software, where the name file
name is in the form
software release 1.00E.
• A computer on the network with TCP/IP and FTP.
Follow these steps to upgrade the AXIS 7000/FX software:
1. Log in to the AXIS 7000/FX with the command
address>
address assigned to the AXIS 7000/FX.
2. You will be prompted for user id and password. Use the user id
which has the default password
3. Issue the command
4. Issue the command
<software name>
axis_7000_fx_1_00e.bin
5. During the flash load, the AXIS 7000/FX LCD will display the
message "
load to finish. This normally takes 1 to 4 minutes. The unit will then
automatically restart with the new AXIS 7000/FX software.
Caution
6. Log out using the command
FTP version.
Notes:
• If you are using a window-based FTP client application such as
Ws_ftp or Fetch, you must rename the new file <software
file> to
product-version.bin
where
<Internet address>
to change to binary transfer mode.
bin
put <software name> flash
is the name of the new software, e.g.
.
" and a progress bar. Wait for the flash
Updating server
quit
before downloading.
flash
AXIS 7000/FX User's Manual
, i.e. axis_
7000_fx_1_00e.bin
ftp <Internet
is the name or Internet
pass.
, or depending on your
bye exit
for
root
where