AXIS 7000/FX User's Manual
Connecting Digital Copiers and Scanners
Important!
•
Check that the power supply provided with your AXIS 7000/FX is marked with the correct
mains voltage.
•
Make sure the scanning device is switched off and the AXIS 7000/FX power supply is discon-
nected. The SCSI bus may become damaged if you connect or disconnect units when power is
on.
Connecting the AXIS 7000/FX to your scanner or digital copier:
1. Switch off the scanning device and disconnect the AXIS 7000/FX
external power supply.
2. Connect the SCSI cable to the SCSI connector on the AXIS 7000/FX.
3. Connect the SCSI cable to the scanning device. The AXIS 7000/FX
uses a built-in SCSI terminator. Note that the scanning device must
also be terminated properly. Refer to the documentation supplied
with your scanner or digital copier.
Basic Installation
19