Safety Notices; Copyright Information - Axis 7000 User Manual

2
Notices

Safety Notices

Take some time to read through the safety notices before
installing the AXIS 7000/FX. Please observe all safety
markings and instructions when using this product.
Caution! -
must be observed to avoid loss of data or
damage to your equipment.
Important! -
must be observed to avoid operational
impairment.
Do not proceed beyond any of the above notices, until you
have fully understood the implications.

Copyright Information

The unauthorized copying of materials that are covered by
copyright and other international proprietary or intellectual
property rights is prohibited in most countries. Axis
Communications AB recommends that the users of this
equipment seek the necessary authorizations for copying
material. The instructions for use in the manual shall not be
considered as an inducement to make illicit duplications of
material. Any duplication will be made at the user's own risk.
Electromagnetic Compatibility (EMC)
USA -
This equipment generates, uses, and can radiate
radio frequency energy and if not installed and used in
accordance with the instruction manual, may cause
interference to radio communications. It has been tested and
found to comply with the limits for a Class A computing
device pursuant to Subpart B of Part 15 of FCC rules, which
are designed to provide reasonable protection against such
interference when operated in a commercial environment.
Operation of this equipment in a residential area is likely to
cause interference in which case the user at his/her own
expense will be required to take whatever measures may be
required to correct the interference. Shielded cables should be
used with this unit to ensure compliance with the Class A
limits.
Europe -
This digital equipment fulfils the
requirements for radiated emission according to limit
B of EN55022, and the requirements for immunity
according to EN55024 residential, commercial, and light
industry (Compliance is not valid for unshielded network
cables).
AXIS 7000/FX User's Manual
Liability
Every care has been taken in the preparation of this manual; if
you detect any inaccuracies or omissions, please inform your
local Axis office. Axis Communications AB cannot be held
responsible for any technical or typographical errors and
reserves the right to make changes to the product and manuals
without prior notice. Axis Communications AB makes no
warranty of any kind with regard to the material contained
within this document, including, but not limited to, the
implied warranties of merchantability and fitness for a
particular purpose. Axis Communications AB shall not be
liable nor responsible for incidental or consequential damages
in connection with the furnishing, performance or use of this
material.
Trademark Acknowledgments
Acrobat, Adobe, AIX, DOS, Ethernet, IBM, Internet
Explorer, Macintosh, Microsoft, Netscape Navigator, OS/2,
UNIX and Windows are registered trademarks of the
respective holders.
Software Trademark Acknowledgments
JPEG code (libjpeg) used courtesy of the Independent JPEG
Group. LDAP code (libldap and libber) used courtesy of the
University of Michigan at Ann Arbor. Copyright © 1991
Regents of the University of Michigan. All rights reserved.
TIFF code (libtiff) used courtesy of Sam Leffler and Silicon
Graphics, Inc. Copyright © 1988-1996 Sam Leffler.
Copyright © 1991-1996 Silicon Graphics, Inc.
Maintenance
It is recommended that you use a moist cloth to clean the unit.
Do not use petroleum based substances as this may cause
damage.
AXIS 7000/FX User's Manual
Revision 1.0
Date: August 2001
Copyright © Axis Communications K.K. 2001