Axis 7000 User Manual page 27

AXIS 7000/FX User's Manual
Using ARP in Windows
Important!
Windows 95 only: If the ARP table is empty, you must first ping an existing unit on your
network before setting the IP address of your AXIS 7000/FX. Type
ARP table.
Notes:
• DHCP is enabled by default but can be disabled by an Administrator
using the System Settings page.
• The IP address and all the other settings will be downloaded automat-
ically. You do not need to restart the AXIS 7000/FX.
In Windows 95 and Windows NT, you can download the IP address
using ARP. Perform the following commands to download the IP
address and verify the communication.
From the DOS prompt, type the following:
arp -s <Internet address> <Ethernet address>
ping <Internet address>
The
Ethernet address
7000/FX with each pair of digits separated by a hyphen.
Example:
arp -s 172.16.253.80 00-40-8c-11-00-86
ping 172.16.253.80
The host will return
message. This indicates that the address has been set and that the
communication is established.
equals the serial number of the AXIS
'Reply from 172.16.253.80...'
Basic Installation
to display the
arp -a
or a similar
27