Axis 7000 User Manual page 22

22
Basic Installation
ARP
RARP
BOOTP
Control Panel
Available in Windows
95/98,
Windows NT, UNIX and
OS/2,
Does NOT work over
routers.
Available in UNIX only.
Available in UNIX only.
Follow the instructions below to set the IP address from the control
panel:
1. Power up the AXIS 7000/FX. Press Menu
appears:
AXIS 7000/FX
Version: 1.00E
2. After a few seconds this display will be shown:
IP address:
000.000.000.000
3. Press Select
Edit IP address:
000.000.000.000
4. Press Menu
one at a time.
5. Use
required.
6. Press Select
7. Press Menu
Default router:
000.000.000.000
Requires the IP address for each new device to be downloaded individ-
ually.
Downloads the IP address to each device automatically. It requires a
RARP daemon on your system and operates within a single network
segment only.
Similar to RARP, but operates on the entire network. It requires a
BOOTP daemon on your system.
to edit the IP address:
to move through the digits and highlight each digit,
to increase or decrease each highlighted digit, as
to confirm the changes.
to display the default router address setting:
AXIS 7000/FX User's Manual
when this display