Axis 7000 User Manual page 44

44
Configuring the AXIS 7000/FX
3. Enter the IP Address of your AXIS 7000/FX, e.g.
Notes:
• If the IP address is changed, you must re-establish the HTTP commu-
nication using the new address.
• You can also set the IP address from the AXIS 7000/FX control panel.
Refer to "Assigning an IP Address" on page 21.
4. Enter the IP address for the Default Router. All traffic directed outside
the local network (according to the subnet mask) is sent to the default
router. Any re-routing via other routers is done automatically. The
setting 0.0.0.0 indicates that no default router is set.
5. Specify the Subnet Mask used for determining when the traffic
should be sent via a router. This number combined with the IP address
identifies on which network the AXIS 7000/FX is located. For
example, the normal class C mask is 255.255.255.0. The setting
0.0.0.0 indicates that automatic router sensing is used.
6. Specify the Domain Name to which the AXIS 7000/FX belongs.
Domain refers to a set of computers on a network that have been
assigned a group name. A domain might contain two or more
workgroups.
7. Specify the IP address of the Primary DNS Server. DNS (Domain
Name System) servers are used for identifying computers with names
instead of IP Addresses.
8. Specify the IP address of the Secondary DNS Server that will be used
in case the primary DNS server is disconnected or unavailable.
AXIS 7000/FX User's Manual
172.16.253.80