Appendix C: The Parameter List - Axis 7000 User Manual

AXIS 7000/FX User's Manual
Appendix C
Important!
Parameter name
[Server]
HardwareAddress
Date
Time
FactoryDefaults
Restart
TimeZone
TimeSyncSource
ServerPassword
DefaultProfile
DefaultPaperSize
The Parameter List
This table below displays the AXIS 7000/FX parameter list. The middle
column shows applicable default values, and the right-hand column a
brief description of the parameter.
The parameters are case dependent and must be entered exactly as in the
table below.
Value
= 00:40:8c:18:02:3c
=yyyy-mm-dd
= hh:mm:ss
= no
= no
= UTC
= NTP
= pass
=Text
= A4
Description
Specifies the AXIS 7000/FX hardware address
which is equal to the serial number.
Specifies the date in yyyy-mm-dd format
Automatically specifies the time zone in which
the AXIS 7000 operates using the Network Time
Protocol (NTP). Time can also be set manually in
hh:mm:ss format using the 24 hour clock.
Note: The AXIS 7000 contains a real time clock
which means that the time will be kept even if
the power is turned off.
Set this parameter to yes to reset to factory
default settings. Note that all current settings will
be lost.
Set this parameter to yes to restart the AXIS
7000/FX.
Specifies the time zone in which AXIS 7000/FX
operates.
Specifies the time source for the AXIS 7000/FX.
Valid values are NTP, Windows (SMB) or None.
Note:
To use Microsoft Windows NT Network (SMB)
properly WINS must be enabled and the
Domain/GroupName parameter must be set to a
valid name.
Specifies the Server password. The
Supervisor/Administrator will be prompted for
this password when trying to access the AXIS
7000/FX for administration tasks. The password
is used in basically all protocols, i.e. HTTP,
SNMP and FTP. Once written to the
configuration file, the password will be replaced
by *'s, representing each letter of the password.
Specifies the default profile.
Specifies the default paper size.
The Parameter List
111