20
Basic Installation
Connecting the AXIS 7000/FX to the Network
Important!
Always consult your Network Administrator before making changes to the network
configuration.
Follow the instructions below to connect the AXIS 7000/FX to your
network:
1. Turn off the AXIS 7000/FX by unplugging the power supply.
2. Connect your AXIS 7000/FX to the network.
Note:
The AXIS 7000/FX is designed for 10 Mbps Ethernet and 100 Mbps Fast
Ethernet networks and connects to the network via a twisted pair
category 5 cable (10baseT and 100baseTX).
3. Switch on the scanning device.
4. Connect the external power supply to the AXIS 7000/FX. The
network indicator will flash during power up and self test. The
following message will appear on the display during self test:
AXIS 7000/FX
Version: x.xxx
where x.xxx is the software version number, e.g. 1.00E
Notes:
The tri-colored Network indicator flashes:
•
yellow - indicating network activity on a 10MB Ethernet network.
•
green - indicating network activity on a 100MB Fast Ethernet network.
•
red -if there is no network connection.
•
Not lit - indicates that there is no network activity.
AXIS 7000/FX User's Manual