Komatsu HB365LC-3 Operation & Maintenance Manual page 118

EXPLANATION OF COMPONENTS
WORKING MODE SELECTOR SWITCH
Use the working mode selector switch (1) to set the movement
or power of the work equipment.
The operation becomes easier by selecting the mode to match
the content of the operation.
P mode: For heavy-duty operations
E mode: For operations with emphasis on fuel consumption
L mode: For fine control operations
B mode: For breaker operations
ATT/P mode: For operation of 2-way attachment like crusher
(For machines ready for installation of attachment)
ATT/E mode: For operations with emphasis on fuel consump-
tion out of that of 2-way attachment like crusher (For ma-
chines ready for installation of attachment)
• When the machine monitor is turned on, it is automatically
set to the mode used when the starting switch was turned
to OFF position last.
• Press the switch to display the working mode selection
screen. For each set mode, P, E, L, B, ATT/P, ATT/E are
displayed on the working mode display (2) at the top right
of the machine monitor display.
• For the machines ready for installation of attachment, the attachment mode is added to the display.
For handling of machines ready for installation of attachment, see "ATTACHMENTS AND OPTIONS
(6-1)".
• When the machine monitor starts up, if the working mode
setting is B mode, the confirmation message in the figure
is displayed and the buzzer sounds.
• Press the switch F6 always when starting up in B mode.
If you press the switch F5, the system starts up in E mode.
If you want to have an automatic setting of P, E, L, B, ATT/P, or
ATT/E mode (optional default setting) when starting the engine,
ask your Komatsu distributor to change the setting.
How to use the working mode selector switch
1.
When the working mode selector switch (1) is pressed, the
Working Mode selector screen is displayed on the machine
monitor.
2.
Press the switch F3 or F4 at the bottom of the screen or the working mode selector switch (1), and the
mode selection is changed one by one.
If no switch is touched for more than 5 seconds, the selected working mode is automatically set as the
working mode. The screen changes to the one for the steps 3 and 4.
3-46
OPERATION