Komatsu HB365LC-3 Operation & Maintenance Manual page 106

EXPLANATION OF COMPONENTS
AUTO-DECELERATION PILOT LAMP
The auto-deceleration pilot lamp shows the setting of the auto-
deceleration function either ON or OFF.
The pilot lamp display when the auto-deceleration switch is op-
erated is as follows.
Auto-deceleration pilot lamp is lit: Auto-deceleration ON
Auto-deceleration pilot lamp is not lit: Auto-deceleration OFF
For the position of the auto-deceleration switch, see "MA-
CHINE MONITOR EQUIPMENT NAME (3-6)".
WORKING MODE DISPLAY
The working mode display shows the setting of the working
mode.
The working mode set with the working mode selector switch is
shown as follows.
P: P mode (for heavy-duty operations)
E: E mode (for operations with emphasis on fuel consumption)
L: L mode (for fine control operations)
B: B mode ( for breaker operations) (For machines ready for in-
stallation of attachments)
ATT/P: ATT/P mode (for operation of 2-way attachment like
crusher, etc.)
ATT/E: ATT/E mode (for operation of 2-way attachment like crusher with emphasis on fuel consumption)
• For the position of the working mode selector switch, see "MACHINE MONITOR EQUIPMENT NAME
(3-6)".
• When E mode is selected, E0 to E03 are displayed. See "ADJUST ECONOMY MODE (3-69)".
TRAVEL SPEED DISPLAY
The travel speed display shows the set mode of the travel
speed.
The travel speed is indicated as follows according to the setting
of the travel speed selector switch.
Lo: Low-speed travel
Mi: Mid-range speed travel
Hi: High-speed travel
For the position of the travel speed selector switch, see "MA-
CHINE MONITOR EQUIPMENT NAME (3-6)".
ONE-TOUCH POWER MAXIMIZING PILOT LAMP
One-touch power maximizing pilot lamp shows if the one-touch
power maximizing function is being actuated.
The following pilot lamp is displayed when the knob switch on
the L.H. control lever is operated. (The actual pilot lamp display
is shown at the position of preheating pilot lamp.)
Pilot lamp lights up: Digging power increases while the knob
switch is kept pressed (for a maximum of 8.5 seconds).
Pilot lamp goes out: Power maximizing function is stopped
For the position of the knob switch, see "MACHINE MONITOR
EQUIPMENT NAME (3-6)".
3-34
OPERATION