Komatsu HB365LC-3 Operation & Maintenance Manual page 316

TRANSPORTATION
PROCEDURES FOR LOADING MACHINE
Load on a firm and level ground.
Maintain a safe distance from the road shoulder
1.
Apply the brake of the trailer securely.
2.
Set the chocks (1) to the tires to secure the trailer.
3.
Set the right and left ramps (2) parallel to each other and
equally spaced to the right and left of center (3) of the trail-
er. Make the installation angle (4) at maximum of 15°.
If the ramps bend a large amount under the weight of the
machine, put blocks under the ramps to prevent them from
bending.
4.
Press the travel speed selector switch (5) to set the travel
speed to low (Lo lights up).
The travel speed (Lo, Mi, Hi) is displayed on the travel
speed display (6).
5.
Turn off the auto-deceleration switch (7) and operate the
fuel control dial to set the engine to low speed.
Each time the auto-deceleration switch (7) is pressed, it
switches OFF to ON to OFF in turn.
When the auto-deceleration switch (7) is turned off, the au-
to-deceleration pilot lamp (8) goes out.
6.
Turn on the swing lock switch to apply the swing lock.
When the swing lock switch is turned to ON position, the
swing lock pilot lamp (9) lights up.
(a): ON position
(b): OFF position
3-244
OPERATION