Komatsu HB365LC-3 Operation & Maintenance Manual page 188

EXPLANATION OF COMPONENTS
Chart of greasing points for auto-greasing
No.
1 Swing circle
2 Boom cylinder foot pin
3 Boom foot pin
4 Arm cylinder rod end
5 Arm cylinder foot pin
6 Boom arm coupling
7 Boom cylinder rod end
8 Bucket cylinder foot pin
Bucket cylinder rod end (unavailable for some specifica-
9
tions)
Bucket - Link coupling pin (unavailable for some specifi-
10
cations)
11 Arm - Bucket coupling pin
12 Arm - Link coupling pin
13 Link coupling pin (unavailable for some specifications)
Outline of the system
This system automatically executes the all of the relevant ac-
tions for greasing. When the starting switch is in ON position,
the grease pump distributes the measured amount of grease at
regular time intervals that have been set beforehand, to all of
the greasing points which are connected to this system.
The selected lubrication interval is displayed within 60 seconds
after the starting switch is turned to ON position with the flash-
ing green lamp (4) on the display inside the cab (2).
(A): Lubrication interval for the light duty work
(B): Lubrication interval for the normal operation
(C): Lubrication interval for the heavy-duty work
How to change the lubrication interval on the auto-greasing monitor
1) Check that the starting switch is in ON position.
2) Select the appropriate interval by pressing the button (3) on
the display inside the cab (2).
3-116
Name of circuit
OPERATION