Komatsu HB365LC-3 Operation & Maintenance Manual page 143

OPERATION
2.
The "Breaker Oil Flow Rate Setting" screen is displayed.
On the "Breaker Oil Flow Rate Setting" screen, you can
perform the following operations with switches F3 to F6.
F3: Decreases the oil flow rate by 1 level.
F4: Increases the oil flow rate by 1 level.
F5: Returns the screen to the "Breaker Setting" screen
without changing the oil flow rate.
F6: Enters the oil flow rate setting and returns the screen
to the "Breaker Setting" screen.
(X): Present oil flow rate setting
(Y): Min. adjusted oil flow rate
(Z): Max. adjusted oil flow rate
ATTACHMENT SETTING
For the machines ready for installation of attachment, you can adjust the oil flow rate in ATT/P mode and ATT/E
mode according to the installed attachment with "Attachment Setting" menu.
For the machines that have no attachment, "Attachment Setting" menu is not displayed.
1.
Select "Attachment Setting" (3) on "Machine Setting" menu
(b) screen, then press the switch F6.
2.
On "Attachment Setting" screen shown in the figure, select
an attachment setting to adjust, and press the switch F6.
On "Attachment Setting" screen shown in the figure, you
can perform the following operations with switches F1 to
F6.
F1: Changes the name of the selected attachment setting.
F2: Changes the oil flow rate of the selected attachment
setting.
F3: Moves to the next item (1 line below). When it is on the
last line, it moves to the first line.
F4: Moves to the previous item (1 line above). When it is on the first line, it moves to the last line.
F5: Cancels the selection and returns the screen to "Machine Setting" menu screen.
F6: Allocates the selected setting to that of ATT/P or ATT/E mode.
Changing "Attachment Setting" name
You can change the name for the attachment setting to desired name.
You can use alphabet letters (A to Z), Arabic numerals (0 to 9), symbols (#, *, +, -, and /), and the blank (space).
EXPLANATION OF COMPONENTS
3-71