Komatsu HB365LC-3 Operation & Maintenance Manual page 218

MACHINE OPERATIONS AND CONTROLS
REMARK
When cleaning the stains deposited on the monitor surface such as dusts, brush them off with a clean, soft
and dry cloth.
For sticky dirt such as oil, remove it with glass cleaner for family use on the market (weakly acid to weakly
alkaline, containing no abrasive), and then finish-wipe with a clean, soft, and dry cloth.
10. Check and clean the rearview mirrors.
Check the rear view mirror for trouble. If it is damaged, repair it. Clean the surfaces of the mirrors and ad-
just the angle so that the area at the rear can be seen from the operator's seat.
11. Check the seat belt and mounting hardware.
Check the seat belt and mounting hardware for any abnormality. If any damage is found, ask your Komatsu
distributor to replace it with new one.
12. Check the bucket with hook (if equipped) for damage.
Check the hook, guide, and hook mount for damage. If any problem is found, ask your Komatsu distributor
for repair.
13. Check and clean the camera
Check the camera for any abnormality. If any problem is found, ask your Komatsu distributor for repair.
14. Remove dirt from around the aftertreatment devices.
Check for dirt and combustible materials (dry leaves, twigs, etc.) accumulated around the aftertreatment de-
vices. If any dirt or combustible materials are found, remove them.
15. Check around the aftertreatment devices for exhaust gas leakage.
Check the pipe connecting the turbocharger to the aftertreatment devices and also KDPF connections for
leakage of exhaust gas (and deposition of soot). If any problem is found, ask your Komatsu distributor for
repair.
16. Check around SCR for exhaust gas leakage.
Check the pipe between the KDPF and SCR and also the SCR connections for leakage of exhaust gas
(and urea deposit). If any problem is found, ask your Komatsu distributor for repair.
17. Visually check the high-voltage wirings.
Visually check the high-voltage wirings for breakage, wear, damage, and loose clamps. If any problem is
found, ask your Komatsu distributor for repair.
18. Check the hybrid component system for water leakage and oil leakage.
Check around the electric swing motor, motor-generator, and lubrication pump for oil leakage, and check
the hybrid component system for water leakage. If any problem is found, ask your Komatsu distributor for
repair.
METHOD FOR CHECKING BEFORE STARTING
Always check the items in this section before starting the engine each day.
HANDLE REFUELLING PUMP
• Do not spill the fuel or overflow the fuel when refuelling (it may cause a fire).
• If the fuel is spilled, wipe it off completely. If the fuel is spilled on the soil or sand, remove the soil or
sand.
• Fuel is highly flammable, and it is dangerous. Never bring any open flame close to the fuel.
3-146
k k
WARNING
OPERATION