Table of Contents
Advertisement
OPERATION
7.
If the machine is equipped with work equipment, set the
work equipment at the front, and drive the machine for-
ward to load it; if it has no work equipment, drive it in re-
verse to load it.
Follow the instructions and signals of a conductor particu-
larly when driving the machine in reverse.
8.
Before moving the machine onto the ramps, check that the
machine is positioned in a straight line with the ramps and
that the centerline of the machine matches that of the trail-
er.
9.
Set the travel direction toward the ramps and drive slowly.
Lower the work equipment as far as possible without caus-
ing interference.
On the ramps, operate only the travel lever. Do not operate
any other lever.
10. When loading a machine with the work equipment instal-
led, at the point where the tracks are on both the ramps
and the ground surface, turn off the swing lock switch, then
swing the upper structure slowly 180°.
11. Turn on the swing lock switch to apply the swing lock.
When the swing lock switch is turned to ON position, the
swing lock pilot lamp (9) lights up.
(a): ON position
(b): OFF position
12. Drive the machine slowly in reverse to load it onto the trailer.
When the machine travels over the rear wheels of the trailer, it becomes unstable. Drive the machine care-
fully and slowly. (Never operate the steering.)
TRANSPORTATION
3-245
Advertisement
Chapters
Table of Contents
