Komatsu HB365LC-3 Operation & Maintenance Manual page 107

OPERATION
REMARK
Only when the working mode is P, E, ATT/P, and ATT/E mode, the power is increased while the knob switch is
being pressed. Even if the knob switch continues to be pressed, the power maximizing operation ends in 8.5
seconds.
AIR CONDITIONER PILOT LAMP
The air conditioner pilot lamp shows the operating state of the
air conditioner.
Pilot lamp lights up: Air conditioner ON
Pilot lamp goes out: Air conditioner OFF
MESSAGE DISPLAY
The message display lights up when there is a message from
Komatsu.
To read the message, see "MESSAGE DISPLAY (3-87)".
Lights up in green (A): There is unread message.
Lights up in blue (B): There is any read message to which no
reply is made.
OFF: No messages
ENGINE STOP PILOT LAMP
The engine stop pilot lamp is displayed while the engine is
stopped. It goes out when the engine is started.
AFTERTREATMENT DEVICES REGENERATION PILOT LAMP
• Exhaust gas temperature may increase higher than the previous models during the aftertreatment
devices regeneration. Stay away from the exhaust pipe outlet to prevent yourself from getting burnt.
Also, do not bring any combustible material close to the outlet of the exhaust pipe to prevent a fire.
• When there are thatched houses, dry leaves or pieces of paper near the job site, set the system to
the regeneration disable to prevent fire hazards due to highly heated exhaust gas during the after-
treatment devices regeneration. For the setting method, see "HANDLE Komatsu Diesel Particulate
Filter (KDPF) (3-118)".
k k
CAUTION
EXPLANATION OF COMPONENTS
3-35