Table of Contents
Advertisement
MAINTENANCE
Grease pump
1.
Lower the work equipment to the ground.
2.
By using a grease pump, apply grease to the grease fit-
tings marked by arrows (2 places).
3.
After greasing, wipe off any old grease that is pushed out.
EVERY 500 HOURS MAINTENANCE
Maintenance for every 50 and 250 hours should be performed at the same time.
METHOD FOR LUBRICATING
NOTICE
•
If any unusual noise is generated from any greasing point, perform greasing regardless of the
greasing interval.
•
Perform greasing every 10 hours for the first 50 hours of operation on a new machine. Also, perform
greasing at 250 hours and 500 hours of operation on a new machine.
•
After the machine is subjected to digging work in the water, be sure to grease the wet pins.
•
When performing heavy-duty operations, such as hydraulic breaker operations, perform the greas-
ing every 100 hours.
1.
Set the work equipment on the level and firm ground in the
maintenance posture as shown in the figure, then lower it
to the ground and stop the engine.
2.
By using a grease pump, pump in grease through the grease fittings shown by arrows.
MAINTENANCE PROCEDURE
4-51
Advertisement
Chapters
Table of Contents
