Komatsu HB365LC-3 Operation & Maintenance Manual page 453

ATTACHMENTS AND OPTIONS
Position (a)
Lock
Position (b)
Only front of pedal can be operated fully (rear is locked)
Position (c)
Both front and rear of pedal can be operated fully
REMARK
Set the lock pin to (a) position except when using the attach-
ment.
When using the breaker, use the working mode selector switch
on the monitor switch portion to set the working mode to B
mode, and set the lock pin to position (b) when using the pedal.
When using the crusher, use the working mode selector switch
on the monitor switch portion to set the working mode to ATT
mode, and set the lock pin to position (c) when using the pedal.
ADDITIONAL FILTER FOR BREAKER
NOTICE
Always install an additional filter in the return circuit on machines equipped with a hydraulic breaker.
The additional filter for breaker prevents deterioration of the hy-
draulic oil when using a breaker.
REMARK
Oil flows only when B mode is selected on the monitor.
ACCUMULATOR
The accumulator is charged with high-pressure nitrogen gas, so improper operation may cause an ex-
plosion, which will lead to serious injury or death. For handling, always observe the following.
• The pressure in the hydraulic circuit cannot be completely removed. When removing the hydraulic
equipment, do not stand in the direction that the oil spurts out when performing the operation. In
addition, loosen the bolts slowly when performing the work.
• Do not disassemble it.
• Do not bring open flame close to it or do not dispose of it in fire.
• Do not perform drilling, welding or flame-cutting.
• Do not hit or roll it, or subject it to any impact.
• When disposing of it, the gas must be released. Ask your Komatsu distributor to have this work per-
formed.
NOTICE
To the machine equipped with a breaker you need to install an accumulator whose model number
matches to that of the breaker manufacturer to the breaker piping . If breaker operation is performed
without having an accumulator installed, the service life of the machine will be reduced. Contact your
Komatsu distributor for further information regarding the breaker.
HANDLE MACHINE READY FOR INSTALLATION OF ATTACHMENT
k k
WARNING
6-11