Table of Contents
Advertisement
MAINTENANCE
5.
If the oil level is above the mark (H) of dipstick (K), loosen
the drain valve (Q) to drain the excessive oil.
Set a container to catch the oil under drain valve (Q) be-
fore draining the oil.
6.
After checking the oil level or adding oil, insert the dipstick
(K) into the oil filler port (J).
METHOD FOR CHECKING OIL LEVEL IN MOTOR-GENERATOR CASE, ADD OIL
Immediately after the engine is stopped, its parts and oil are still very hot, and may cause burn injury.
Wait for the temperature to go down, and then start the work.
1.
Remove the dipstick (G) from the oil filler port (F) and wipe
off oil on it with a cloth.
2.
Insert the dipstick (G) fully into the oil filler port (F).
3.
Pull out the dipstick (G) and check that the oil level is be-
tween the (H) and (L) marks on the dipstick.
4.
If the oil level does not reach (L) mark on dipstick (G), add
oil through oil filler port (F).
5.
If the oil level is above (H) mark on dipstick (G), remove
the cover (A) under the motor-generator, and loosen the
drain valve (P) to drain the excessive oil.
6.
After checking the oil level or adding oil, insert the dipstick
(G) into the oil filler port (F).
REMARK
If the machine is inclining, make it level before checking.
k
k
WARNING
MAINTENANCE PROCEDURE
4-63
Advertisement
Chapters
Table of Contents
