To Set Back Fade Time Channels; Inverting Channels; Provide And Put Back Invertings - GLP SCAN OPERATOR FX User Manual

SCAN OPERATOR FX

3.12.2 To set back Fade Time channels.

In order to activate the Fade time function for all channels, you proceed as follows:
1. Activate Setup mode (SETUP key).
2. Now select "Fadetime". In the menu of the Setup mode.
3. Press the DELETE key.
For confirmation you will receive the message "Fadetime RESET".
Important:
4. The changes are not automatically durably stored but they are directly active.
Therefore it is necessary that you confirm the changes for durable storing once
with the RECORD or the SETUP key.
5. Press the SETUP key for 3 seconds to leave Setup mode again.

3.13 Inverting channels

Each of the 192 channels can be inverted individually. Inverting takes place in the
Setup menu and is deleted likewise with the deletion of the entire memory.

3.13.1 Provide and put back invertings

To invert or put back the channels you proceed as follows:
1. Activate Setup mode (SETUP key).
2. Now select „Invert" in the menu of Setup mode. You can now invert the
channels.
3. Select desired fixtures with appropriate Fixture keys. Several fixtures can be
selected at the same time for treatment.
4. Use the scenes keys, in order to individually switch the channels on or off. In
the display the respective condition will be shown as "Channel Inverted" or
"Channel normal".
5. If necessary press the PAGE key, in order to be able to change the further 8
DMX channels (channels 9-16).
36
(V1.3)
GLP German Light Products