Change The Editing Position Of A Chaser - GLP SCAN OPERATOR FX User Manual

SCAN OPERATOR FX
1. Activate PROGRAM mode (PROGRAM Key).
2. Select the desired Chaser with the CHASER keys 1-6.
Reference:
3. If you switch on a Chaser that is already containing steps in the program
mode, the point of editing will automatically be set to the last step of the
chaser. Inserting now takes place at the end of the Chaser. Press the BANK
UP/DOWN key to call up the bank on which the desired scenes were stored
to. Press the MUSIC/BANKCOPY key.
4. Press the RECORD key. As memory confirmation you will receive the
message "bank Inserted".
3.7.3

Change the editing position of a Chaser

Since the functions for inserting a bank and for inserting a step always insert it
behind the current step of a chaser, it can be desirably, in particular during the
rework of a Chaser, to change the current editing position.
1. Activating PROGRAM Mode (PROGRAM key).
Select the desired Chaser, if it is not yet activated.
Reference:
2. If you switch on a not empty Chase in the Program mode, then the editing
position will be the last step of the chaser. Inserting takes place at the end of
the Chasers.
3. Press the TAPSYNC key. You now see the current Chaserstep: "step xxx" in
the Display.
22
(V1.3)
GLP German Light Products