Receiving Data; Sending Data - GLP SCAN OPERATOR FX User Manual

SCAN OPERATOR FX

3.23.2 Receiving data

In order to transmit the data, you must continue now with the receiving unit as
follows:
1. Keep the keys of the Fixtures 7 and 12 pressed at the same time, with the
controller switched off.
2. Switch the controller on now, while you keep the keys pressed.
3. The display now shows "Serial/Rec. 000% ". The desk is ready to receive the
data and is waiting.
4. As soon as the unit is receiving data, the percentage value shown will
increase. When 100% are reached, the copy-progress has been finished
successfully.

3.23.3 Sending data

If the receiving desk is ready, start the transmission procedure of the other
equipment as follows:
1. Keep keys of the Fixtures 1 and 6 pressed at the same time, when the
controller is switched off.
2. Switch on the Scanoperator now, while you keep the keys pressed.
3. The Display is showing "Serial/sends xxx%" and the percentage value
will count up slowly. The value shown in the controller that is receiving
the date should increase as well. The transmission procedure lasts
approx.. 90 seconds.
4. Transfer was successfully locked, if both devices reached 100%.
In the case of errors:
It might happen that the receiving unit stops with the progress below
a.
100% - If that happens, try to restart the data transmission.
b. If the waiting controller shows no reaction, although the other unit
already sends, then the error probably lies in the connection of the
cable!
52
(V1.3)
GLP German Light Products