GLP SCAN OPERATOR FX User Manual page 17

1. Activate PROGRAM mode (PROGRAM key).
2. Select desired Fixtures with associated Fixture keys. Thereby several Fixtures
can be selected at the same time.
3. Adjust the desired DMX values (0 to 255) with the Fader.
4. If you need to change to channels 9-16 press the "Page" key. If you'd like to
edit channel 1-8, just press the "Page" key again.
Repeat the steps 2-4 until all DMX values correspond to your desires.
Note:
By pressing the RELEASE key you can set all 192 channels back to the DMX
value "0" at any time and start altering the values again.
For storing continue with step 5:
5. If the current bank does not match the desired bank, then you might select the
desired bank using the BANK keys. 30 banks are available. You can store up to
8 Scenes in each bank.
If the desired scene is created, then you can store it in the scanoperator by
pressing the RECORD key once.
6. Afterwards press the scenes key, which you would like to store the scene to.
As a memory confirmation you'll receive the message "Scene Saved". After that,
the display will show the current bank and scene.
7. Continue the steps 2-7 until all desired scenes are stored.
8. To leave PROGRAM mode, press the PROGRAM key for 3 seconds.
GLP • German Light Products
(V1.3)
SCAN OPERATOR FX
17