Deleting Scenes; Deleting Banks; Programming Chasers - GLP SCAN OPERATOR FX User Manual

SCAN OPERATOR FX
6. Press the PROGRAM key for 3 seconds to leave the PROGRAM mode again.

3.6.6 Deleting scenes

1. Select the bank, in which the scene that shall be deleted is located.
2. Keep the DELETE key pressed and press the scenes key of the scene that
you would like to delete. As confirmation you receive the message "Scene
Deleted".
Attention:
A deleted scene cannot be restored again!

3.6.7 Deleting banks

1. Select the bank, which you would like to delete.
2. Keep the DELETE key pressed and press the MUSIC/BANK key at the same
time.
3. All scenes of this bank were deleted. For confirmation you receive the
message "Bank Deleted".

Programming Chasers

3.7
A Chaser is a program, which calls at maximum of 250 scenes successively. You must
have programmed the scenes, from which you "build up" the Chaser, before.
.
Should you change scenes later, the program of the Chaser changes as well. Should a
scene in which a chaser is used, be deleted afterwards, then the chaser will not load the
scene, since it is empty.
20
(V1.3)
GLP German Light Products