GLP SCAN OPERATOR FX User Manual page 26

SCAN OPERATOR FX
1. Activate PROGRAM Mode (PROGRAM key)
2. Now select the bank 31 and/or the position, where the bank 31 would be. The
display will now show "Overlay". You can now configure the Blackout function
like a normal scene.
3. If you want to provide a new Blackout function, then you can continue directly
with step 5, if you follow the following reference.
Reference:
If you want to overwrite a few channels only (for example the Shutter
channel of the lights), it is advisable to press the "Release" key first, which
sets all channels to "Off". Afterwards only the channels that should really
be overwritten, can be turned on.
4. However If you would like to edit the existing Blackout function, load it now by
pressing the Blackout key once.
5. Select the desired fixture with the appropriate Fixture key. Several Fixtures can
be selected at the same time.
6. Use the scenes keys, in order to switch the channels on or off individually. The
display will show a short message saying "Channel XY: On "or" Channel XY:
Off". "On" means that Blackout overwrites this channel fo the selected Fixtures.
7. With the Faders you can set the desired values. You might Output values,
which are not to be overwritten (status "off"), as well. This can be sense full for
programming, for example if you would like to switch on a dimmer, in order to
see that the Shutter is really "closed". The Blackout function will ignore these
values later, if they were stored with the status "off".
8. Repeat the steps 3 to 6, in order to configure further Fixtures
9. If the desired Blackout function is provided, then store it by pressing the
RECORD key.
10. Afterwards press the BLACKOUT key. The procedure corresponds to the
sequence, as if you wanted to store a normal scene on the Blackout -Key.
11. For confirmation you will receive the message "Scene Saved".
12. Press the PROGRAM key for 3 seconds to leave PROGRAM mode.
26
(V1.3)
GLP German Light Products