Delete Entire Memory; This Function Clears And Initializes The Entire Memory. After The Deletion The; Memory Will Be In The Following Condition; Blackout Configure - GLP SCAN OPERATOR FX User Manual

Delete entire memory

3.8

This function clears and initializes the entire memory. After the deletion the

Memory will be in the following condition:

•
• All Chaser are deleted
• All overlay scenes are deleted
• The Blackout-Key overwrites all 192 channels with the value "0"
• No channel is inverted
• The pan channel for each Fixture is channel 1
• The Tilt channel for each Fixture is channel 2
• The Midi channel is channel 1
• The Midi allocation is adjusted to the "Midi key board" allocation
• The autostart function is deactivated
For deletion you proceed as follows:
1. The controller is switched off.
2. Hold the Program and Setup keys pressed while you switch the controller on
again.
3. For confirmation you will receive the message "MEMORY RESET".

Blackout configure

3.9
3.9.1 Provide and edit Blackout function
You can program the Blackout function freely according to your desires. You can set
whether each channel of any fixture will be overridden, and if so, with which value.
It is possible to configure the Blackout function so that it only closes the Shutter of all
fixtures but the movements and effects continue to run.
For providing or editing the Blackouts function you proceed as follows:
GLP • German Light Products
All scenes are deleted
(V1.3)
SCAN OPERATOR FX
25